MS17796B
2. Order of precedence. In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. Intended use restrictions. These bearings are not intended for reaming on assembly. CHANGES FROM PREVIOUS ISSUE. Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
C
E E
R
D B A
Chamfer .003 S E S
FIGURE 1. Bearing configuration.
TABLE I. Dash numbers and dimensions.
Dash no. |
Static capacity (lbs.) |
C Length |
Nominal ID |
A-basic ID |
R-radius (max.) |
B-basic OD |
D-flange OD |
E-flange thickness |
1 |
75 |
1/8 |
3/32 |
0.095 |
1/32 |
0.159 |
3/16 |
1/32 |
2 |
125 |
3/16 |
||||||
3 |
175 |
1/4 |
||||||
4 |
96 |
1/8 |
1/8 |
0.127 |
1/32 |
0.1895 |
1/4 |
|
5 |
160 |
3/16 |
||||||
6 |
222 |
1/4 |
||||||
7 |
65 |
1/8 |
0.253 |
3/8 |
1/16 |
|||
8 |
130 |
3/16 |
||||||
9 |
193 |
1/4 |
||||||
10 |
255 |
5/16 |
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business