MIL-B-13501D (MI)
Exterior containers shall be of minimum cube and tare consistent with the protection required.
As far as practical, exterior containers shall be of uniform shape and size and contain identical
quantities. Containers shall be closed and strapped as specified in the applicable specification
or appendix thereto. Gross weight shall be not greater than 200 pounds or as specified by the
container specification.
5.2.3 Level C. Level C packing shall be as specified in MIL-STD-1190.
5.3 Marking. In addition to any other marking required by the contract or order,
interior and exterior shipping container shall be marked as specified in MIL-STD-129.
6. NOTES
(This section contains information of a general or explanatory nature that may be
helpful, but is not mandatory.)
6.1 Intended use. Bearings and bushings covered by this specification are intended for
use as follows (see 3.2):
a. Alloy A (wrought solid brass) is hard, strong, and has good fatigue resistance. It is
used in applications of intermediate load oscillating motion such as tie rods, brake shafts, etc.
b. Alloy B (wrought solid bronze) is a general purpose bearing material, good shock
and load capacity, is high temperature resistant, hard shaft desirable, and less score resistant
than
the alloys containing higher lead contents. Used for moderate to high loads, such as
transmission bushings and thrust washers, piston, pin bushings, etc.
c. Alloy C (wrought or cast bronze) has heavy load carrying capacity, low coefficient
or friction, good resistance to abrasion and is non magnetic. Used for pinion bearings and
general machine bushings.
6.2 Acquisition requirements. Acquisition documents must specify the following:
a. Title, number, and date of the specification
b. Issue of DODISS to be cited in the solicitation, and if required, the specific issue of
individual documents referenced (see 2.1.1)
c. Chemical composition of the bearings or bushing (see 3.2)
d. Drawings, when required, providing dimensions, tolerances, hardness, and other
design details (see 3.3, 3.5 and 3.6).
e. When first article is required (see 3.1 and 4.4)
7
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business